Fit4Home TF-7005A, User Manual

Page: 11 / 28

11
STEP 2
1. Now position the net plate
(D4) over the base frame (A2)
as shown in the diagram.
2. Now position 2 rubber
bushings (E4) on the net plate
(D4), so they are aligned with
the base frame (A2) holes.
3. Insert the 2 guide rods (A6)
into the base frame (A2),
through the rubber bushing
(E4) and the net plate (D4).
4. Now secure the guide rods
into the base frame, with 2
bolt (B5), 4 washers (B17) and
2 nuts (B13).
5. Slide the weight plates (E23)
into the guide rods (A6).
6. Insert the select rod (A5) into
the weight plates (E23).
7. Then Install the select rod
bushing (E9) onto the select
rod (A5). Please note, the rod
bushing hole is aligned with
the top hole (on the select
rod).
8. Then insert the select rod
pin (C3) in the top hole of the
select rod (A5).
9. Now slide the weight block
(E22) through the guide rods
(A6).
10. Then slide the net frame (D4)
through the guide rods, the
place the 2 positioning rings
(E5) at the top of the rod.
ASSEMBLY INSTRUCTIONS