F4000N Series Operating Manual
Section 5: Point Type & Function Reference
Part # 562187N-1
Rev. D Sep 2012
69
© 2012 Fisnar Inc.
3.5
Lock or Unlock Program
Lock or Unlock Program
allows the user to protect a program from editing. If the program
is locked, the user will not be able to change any of the program data. Unlocking the
program will allow the data to be changed again.
3.6
Password Setup
Password Setup
allows the password to be set or reset for the current program.
The purpose of the password is to protect the program from unauthorized editing. The
user will not be allowed to enter TEACH mode unless the correct password is entered. If
the password is forgotten, the master password (777) can be used to gain access to the
program.
To set the password, select
F2 (MENU 1)
,
Utility Menu
,
and
Password Setup
. The user
will be prompted for a
NEW PASSWORD
. Type the new password and press
ENTER
.
If the password is left blank and
ENTER
is pressed, the password will be removed. After
changing or resetting the password, the robot power should be turned off.
3.7
Cycle Counter
When in run mode, the first line of the display shows the number of program cycles, which
have run to completion for the current program number: [RUN MODE][
X
]
It is possible to reset this number by selecting
F2 (MENU 1)
,
Utility Menu
,
Cycle
Counter
. When prompted for the
New Data:
press
0
and
ENTER
to reset the cycle
counter.
It is also possible to cause an alarm to be generated after a fixed number of program
cycles. Select
F2 (MENU 1)
,
Utility Menu
,
Cycle Counter
. When prompted for the
New
Data:
type the number of program cycles to complete before generating the alarm and
press
ENTER.
In run mode, when the set number of program cycles has been completed, the display will
show
Counter Full [Shift+Enter]
and by pressing the shift+enter buttons the robot will be
disabled and you can run the program again.
Summary of Contents for F400N Series
Page 118: ......
