- 3 -
Preamp Installation cont
inued…
The signal wire goes to the terminal marked “IN”
and the shield goes to the
“GND” terminal.
Reminder:
Do not shorten the pickup wire. Tighten
the screws on the terminal block to secure the wire.
Replace the preamp’s cover being sure the wires do
not get pinched by any plastic parts. The housing
should easily fasten tightly when the screw is
replaced.
Fasten the Preamp/Jack in the Endpin Hole
Follow this sequence when installing the endpin jack:
1 - Large Hex nut
2 - Large Dress Washer
3 - Star Washer
Guitar End Block
4 - Small Dress Washer
5 - Small Dress Nut
6 - Strap Button
Thread the large nut, dress washer and star washer down the
jack towards the preamp body to allow the proper amount of
the jack to go through the end block.
For proper fit, the Endpin Jack should protrude at least 5/16"
(7.9 mm) and no more than 11/32" (8.7mm) outside the
guitar's body.
Fit the small dress washer and nut over the end of the jack
and tighten the nut with a 1/2" open-end wrench while
counter-holding the jack in place with an Allen wrench or
small screwdriver.
.
