- 6 -
Clean the area where you will mount the bag with an
alcohol wipe or cotton swab moistened with rubbing
alcohol. Let dry.
Battery Bag Installation contin
ued…
Note:
It is important to make sure the area is clean and
free of dust or any foreign matter that will compromise
the adhesive.
Separate the battery bag and Hook and Loop patch. Peel
off the plastic film from the hook and loop patch and
place it in the chosen location. To set the adhesive,
burnish the entire area of the patch, especially the
edges.
Connect a 9V battery to the battery cable and tuck it into
the bag. Press the bag firmly onto the hook and loop
patch inside the instrument. The adhesive under the
patch requires 24 hours to achieve a full bond.
Cable Management
Secure the wires inside the instrument with the supplied
adhesive-backed clips. Clean the bare wood surface
where you will fasten the clips. Use an alcohol wipe or a
c
otton swab moistened with rubbing alcohol.
Suggested wire clip placement:
Installation Options
Installation without control module
Under normal installations, the Volume and Tone control
module is installed in the soundhole. Optionally, the Infinity
VT preamp may be installed without these controls
. The
Volume and Tone module cannot be removed from the
Infinity Mic Blend.
Note: Installing the preamp without the control module will
also eliminate the module mounted voicing switch. Voicing
may still be adjusted using the switch mounted on the main
preamp PCB.
