- 5 -
Control Module Installation continued…
Peel back the release film on the bottom of the control
module, add a small dot of gel type cyanoacrylate to the
center of the adhesive and fasten the preamp to the
underside of the soundhole. Locate the module flush
with the edge of the soundhole, on the bass side,
between the transverse brace and the bass-side x-brace
(see illustration). Apply even, steady pressure to the
module for 30-45 seconds to set the adhesive. The
adhesive achieves maximum hold after 24 hours.
Note:
If installing the Infinity Mic Blend, repeat these
steps to install the Blend module on the opposite side of
the soundhole.
Mic Module Installation
(Mic Blend only)
The Infinity Mic Blend mic module mounts in the
soundhole adjacent to the neck block at the base of the
fingerboard. The mount should be placed as close to the
blend control module as possible. It there is a flat brace
that will not allow the mount to sit on the edge of the
soundhole, the mount can be placed directly on the
brace.
Note:
For Nylon string guitars, or to accommodate
guitars with unique bracing patterns, this position can
be adjusted slightly to the left or right without
adversely affecting the microphone response.
Test the area where you will mount the mic module. Remove
any lacquer and/or buffing compound from this area using
fine grit sandpaper. Clean this surface with an alcohol wipe or
a cotton swab moistened with rubbing alcohol and let dry.
Note:
For the strongest bond we recommend a water-based
primer/sealer be applied to the bare wood inside the
soundhole. A light film of yellow wood glue spread by
fingertip works well for this application. Let the primer/sealer
dry before continuing.
Peel back the release film on the bottom of the mic module
and fasten the preamp to the underside of the soundhole.
Locate the module as shown in the diagram. Apply even
steady pressure to the module for 30-45 seconds to set the
adhesive. The adhesive achieves maximum hold after 24
hours.
Note:
The mic module may be adjusted to hold the mic
capsule in multiple angled positions. Set the mic angle to
achieve the desired mic response for your guitar. (See User
Guide)
Battery Bag Installation
Install the battery bag in your desired location inside the
guitar. The two most prominent locations for this are the
neck block or on the back of the guitar in the shoulder area.
