6
START UP
1.
Place reel in cranking mode. Make certain that the bail is NOT open for casting.
2.
Rotate PWM dial 1/4 turn to activate the PWM.
3.
While holding the rod and reel normally, push the Rocker Switch in any direction
to cycle the reel.
4.
Next push the Rocker Switch in the opposite direction and check rotation. Note
which Rocker Switch position actuated PRESET and HIGH speed.
5.
For PRESET speed operation, user may set the PWM dial to any
preferred speed up to maximum. Once chosen, the PRESET speed position of
the Rocker Switch will recall the assigned speed. PRESET speed preference
may be changed at any time
by rotating the PWM dial to
another position.
6.
At any time, user can instantly
select HIGH speed (FULL
Power) by simply pressing the
Rocker Switch in the opposite
direction. HIGH speed is
immediately available once
the battery is connected and
turned "ON."
OPERATION
1. After casting the line, return the bail to cranking mode, by hand.
Do NOT close
the bail using the motor and NEVER attempt to rotate the bail manually.
Doing so will damage the gear motor drive assembly and require service.
