5
(g)
Remove the remaining release paper from the 3M VHB™ Tape.
(h)
Belt clip should be mounted
lengthwise, inline and centered on
the battery enclosure. Thick end of
the belt clip should be approximately
1/2" below the battery end with LED,
switch and jack. Press firmly to set
tape adhesive.
4.
Orient the PWM enclosure dial in the same
direction as the LED, switch and jack of the battery unit. Affix the PWM enclosure
to the battery by joining both 3M Dual Lock® surfaces together. Test that both
components are securely held by the 3M Dual Lock® strips.
5.
Make sure battery is OFF. Then
plug in PWM power lead into
battery IN/OUT jack.
6.
Turn ON battery switch. Battery
LED indicator will illuminate.
System will be powered and ready
for use.
