4
4.
SMART BATTERY
1.
Abide by all safety warnings and disclosures listed in the enclosed battery user
manual.
2.
Follow these steps to properly charge the SMART BATTERY:
(a)
Place battery switch in "OFF" position. See side of battery enclosure for "ON
OFF" reference mark.
(b)
Plug wall charger DC jack into battery.
(c)
Connect wall charger AC plug to an appropriate receptacle. The battery LED
light will glow RED. The charger plug LED light will glow GREEN.
(d)
IMPORTANT: Turn battery switch "ON." If battery switch remains "OFF"
charging will NOT take place! The charger plug LED light changes from
GREEN to RED.
(e)
Full charge is achieved when charger plug glows GREEN, usually between 8
and 12 hours.
(f)
Turn OFF battery switch before disconnecting leads.
(g)
Remove Charger from battery. Store Charger for future use.
3.
An optional Belt Clip is included with each battery pack. Once installed, the
battery and PWM enclosure can be easily attached to a belt, allowing full user
mobility.
(a)
To assemble the battery belt clip, orient the battery face to the side
OPPOSITE the two 3M Dual Lock® strips.
(b)
Use the supplied alcohol swab to wipe and prepare the battery
surface.
(c)
Use the supplied alcohol swab to wipe and prepare the shorter side
of the belt clip.
(d)
Wait until the surface alcohol completely evaporates from all
surfaces.
(e)
Peel release paper from one side of the 3M VHB™ Tape.
(f)
Align onto short side of belt clip. Press firmly to set.
