www.eu.fishersci.com/fisherbrand
22
This water system has the following alarms. If the system is not
working properly, the corresponding warning message will appear
at the fourth row on the display panel.
•
Low Water Pressure: System monitors inlet water pressure at all
time. If system water inlet has no water, or water pressure is below
0.05 MPa, system displays "Low Pressure" and automatically goes
to Standby to protect the system.
•
RO Failure: When RO water conductivity is above a preset upper
limit, system displays "RO > Set Point", the RO indicator light
blinks. It is normal that RO water is above the upper conductivity limit
at the first few seconds of the RO flush. This message disappears
after RO reaches quality standard, and the green light stops blinking.
If the blinking of RO indicator light continues, replace the RO
membrane.
•
UP Failure: When UP water resistivity is below the set limit, UP
indicator light blinks. It is normal that UP water is below the set limit
at the first few seconds of the Cleaning. This message disappears
after UP reaches quality standard, and the green light stops blinking.
If the blinking of UP indicator light continues, replace the U pack
cartridge.
•
Cartridge Life Reminder: System has preset cartridge usage timers
(countdown) for both P Pack and UV lamp. System reminds you to
replace them when these consumables are about to run out or have
been exhausted.
