Door Handles
(Swinging Door Models Only)
Door handles are packed inside each refrigerator. To
mount the handle, lift the door gasket behind the two
screws on the front of the door. Attach handle with offset
away from the cabinet corner and tighten the screws.
Door Removal and Adjustment
(Sliding Door Models Only)
Each door has its own closing spring located at the top of
the door track. Each spring is set for proper tension. If
adjustment is required:
1. Check for cabinet level (see above).
2. Remove the door(s) by lifting it and sliding about
half way open. The roller will fall into a gap in
the upper track. While maintaining upward
pressure on the door, pull the bottom outward
until it clears the bottom track.
3. Adjust the location of the door rollers in the
roller brackets (above door) as shown by loos-
ening the lock nut on the back of the roller
bracket and moving the roller up or down.
4.
The spring tension can be adjusted by moving
the spring to the outside hole of the bracket or
by snipping a portion of it off and then refasten-
ing it to the bracket.
U
NPACKING AND
I
NSTALLATION
Note
The refrigerator must be level in order
to provide adequate condensation
drainage as well as proper door align-
ment and operation. The refrigerator
should be in its final operating loca-
tion and set so that it is firmly posi-
tioned on the floor.
Closing spring
Lock nut on back
Roller
Figure 1
Warning
Wear safety glasses before snipping
spring.
6
