Before operation, become familiar with the refrigerator
controls located on the refrigerator header panel. A layout
of the controls is given below.
Controls Layout
Begin operation by inserting the key into the key switch
located on the header panel. The key switch is packed
inside the envelope, which is shipped in the refrigerator
chamber. Turning the key switch to the ON ( | ) position
will energize the evaporator fans and the digital controller.
Temperature Controller
The digital temperature controller is located on the left
side of the header panel (See Figure 4). When the unit is
initially turned on, the display will indicate current cham-
ber temperature. The temperature units will be indicated
by the °C or °F LED located just to the right of the tem-
perature display. The refrigerator is factory set at 4°C.
When the unit is first energized the evaporator fans will
operate however it will not immediately cool. A 3-minute
compressor delay is programmed into the controller to
provide sufficient time for the evaporator to defrost and to
allow the system pressure time to equalize. When the
delay time is over, the Cool LED will illuminate, the com-
pressor will run and the chamber will cool.
Operation
Warning
If the unit is tilted in excess of 30
degrees, do not apply electrical power
for a minimum of 12 hours.
Warning
This product is NOT approved for stor-
age of flammable or explosive materi-
als. Also, it is NOT approved for use in
hazardous locations containing explo-
sive atmospheres.
I
O
POWER
Light Switch
Units LED'S
Mode LED
Cool LED
Key Switch
Digital Display
Menu Keypad
Up Arrow Keypad
Down Arrow
Keypad
Figure 4
9
Note
The compressor requires a 3-minute
delay time between activations. The
unit will not cool during this delay.
The delay is also activated when the
controller is first energized.
