18
!3
ASSEMBLE THE DOOR AND DRAWER PANELS
IMPORTANT!
●
●
Ensure door panel dimensions are correct for your refrigerator.
●
●
The assembly of standard Fisher & Paykel kits (Stainless steel door panels) and custom door panels are outlined below. For standard Fisher & Paykel kits, only
remove the protective film for handle installation. This will protect the finish of the door panels until installation is complete.
1
Mounting handle
For Fisher & Paykel kits,
remove plastic plugs (4x)
from handle pilot holes
on panel. Align handle
to holes and secure with
screws (4x).
For custom panels,
ensure handle is
mounted 65mm from
inner edge of panel to
the centre – this will
avoid interference with
brackets.
2
Hanging bracket
For Fisher & Paykel kits,
align bracket to pilot
holes and secure with
M5x14 Mush Phillips SS
(4x).
For custom panels,
secure bracket with
screw washer (4x).
3
Side brackets and straps
For Fisher & Paykel kits, align bracket and
strap to pilot holes on the sides of the panel.
Secure with M5x14 Mush Phillips SS (2x).
For custom panels, secure bracket with
screw washer (2x).
Repeat this process for the remaining
brackets and straps (4x) French door panel.
Repeat this process
for the next French
door panel.
Drawer panel
French door panel
4
Mounting handle
For Fisher & Paykel kits,
remove plastic plugs (4x)
from handle pilot holes
on panel. Align handle
to holes and secure with
screws (4x)
For custom panels,
ensure handle screw
heads are counter sunk
into back of panel to
avoid interfering with
hanging bracket.
5
Hanging bracket
For Fisher & Paykel
kits, align bracket to
pilot holes and secure
with M5x14 Mush
Phillips SS (6x).
For custom panels,
secure bracket with
screw washer (6x).
6
Side brackets and straps
For Fisher & Paykel kits, align
bracket and strap to pilot holes on
the sides of the panel. Secure with
M5x14 Mush Phillips SS (2x).
For custom panels, secure bracket
with screw washer (2x).
Repeat this process for the
remaining brackets and straps.
