517766
March 2003
- 41 -
235.
(11101011) Phase 6 - Lid Lock Short Circuit
Lid Lock fault, not activated when instructed to by the motor controller
Primary Fault:
Lid Lock mechanism has jammed or failed
Action:
Check resistance across the connections, should be around
73
ohms
, if not within
5 ohms
replace the Lid Lock.
236.
(11101100) Phase 6 - Incompatible EEPROM Version
Failure to start and fault immediately displayed
Primary Fault:
Motor controller is the wrong one.
Action:
Replace motor controller.
237.
(11101111) Phase 6 - Temperature Sensor Error
The electronics have picked up a continuity problem, same as fault code 10 or 41.
Primary Fault:
The sensor has failed either in the harness or connection to the
thermistor.
Action:
Replace the Thermistor (temperature sensor)
Secondary Source:
Motor controller has failed to read the temperature,
check connections.
Action:
Replace motor controller if connections look fine and the fault still occurs.
238.
(11101110) Phase 6 - Lid Lock Fail In-Line Test (1)
Final on line tests, final check before going to the field.
239.
(11101111) Phase 6 - Lid Lock Fail In-Line Test (2)
Final on line tests, final check before going to the field
240.
(11110000) Phase 6 - Hall Out Of Order. RPS Fault
Same as previous Hall Error faults, just an extra fault code for phase 6, see code
130,131 for directions.
241.
(11110001) Phase 6 - Function Time Out
Display crashed
Primary Fault:
Display has failed
Action:
Replace Display Module
Secondary Fault:
Motor controller has failed
Action:
Replace Motor controller
242.
(11110010) Phase 6 - OOB Hit Greater than Max for 5 Sec
Out Of Balance warning to the user, additional fault code for Phase 6
Primary Fault:
Machine has detected the Tub movement to be excessive or the
Micro switch is permanently on or harness to it is disconnected.
Action:
See fault code 43 for details.
243.
(1110011) Phase 6 - Stepper Test Failure
Rotor Position Sensor Fault, the motor controller has attempted a motor step test
and found the motor has not stepped to the correct position.
Primary Fault:
Wiring
Action:
See Fault code 53 and 54.
Summary of Contents for ecosmart GWL11
Page 2: ...517766 March 2003 ...
