11
INSTALLATION INSTRUCTIONS
!6
測試工作
!4
在看得見的地方貼上備用資料標籤並插好氣體煮食爐電源插頭
!5
安裝平底鍋架
備用資料標籤
GAS
ON
GAS
ON
PTFE
3⁄8
”
NPT
500 mm
50 mm
1
2
500 mm
25 mm
25 mm
500 mm
NG
NG
LPG
LPG
20-50 mm
½
“ BSP
½
“ BSP
x 4
1
1
2
2
16-20mm
20-30mm
Fibre washer
Floating nut
Elbow (½” BSP external thread)
LPG test point adaptor (if using LPG)
m
in
S
A
R
m
in
A
F
S
REAR CLAMPS
FRONT CLAMPS
40 mm
40 mm
30 mm
30 mm
30 mm
30 mm
Foam Tape
Adhesive side
Fibre washer
Floating nut
Elbow (½” BSP external thread)
NG Models
ALL Models
Make sure the connection point will be accessible with the cooktop installed.
To enable the gas supply to be readily shut off by the customer, make sure the connection
is fitted with an isolating valve close to the cooktop.
Make sure to fit the supplied
washer and regulator.
Adjust to obtain a
test point
pressure of 1 kPa
with the two
semi-rapid burners operating at
highest setting.
Ensure the hose is long enough to allow for removal of cooktop for servicing.
Make sure the connector is located as shown in step 3 CLEARANCE DIMENSIONS.
The hose assembly must be AS/NZS 1869 Class B or D certified, with an Rp ½” (ISO 7‐1) female thread connection.
The hose assembly must be as short as practicable and comply with relevant AS 5601/NZS 5261 requirements.
The hose must not be kinked, subjected to abrasion or permanently deformed.
The hose must not be near or in contact with any hot surfaces
(e.g. base of metal hotlplate, flue, or chassis of underbench oven etc.)
If connecting the gas with a flexible hose:
LPG Models
check all connections
Make sure to fit the supplied
washer and test point adaptor.
Make sure the
supply pressure
is regulated to 2.75 kPa
, with
the two semi-rapid burners
operating at highest setting.
Washer
Washer
焰尾呈黃色
火焰噴離爐頭
正常火焰
Arrow
x 4
x 4
30-40mm
40mm+
分開點燃每個爐頭，然後點燃所有爐頭，檢查點火系統是否正常工作。
檢查火焰是否呈藍色，焰尾不帶黃色。
如果發現異常，檢查爐頭零件安裝是否正確。
如果無法實現正常工作，請聯絡客戶服務部。
在氣體煮食爐能正常工作之前，使用者不得使用氣體煮食爐。
確保平底鍋架放到位，
且方向正確
（參看
使用者指南
）