478182
35
6.2.2 Restart
Feature
The LCD AquaSmart™ leaves the factory with the RESTART set to the ON position, which is
indicated in the screen by the word RESTART highlighted. To turn the RESTART feature OFF,
push the Left scroll arrow. This will remove the highlight from the word RESTART. When the
machine is being serviced, it is more convenient to turn the RESTART feature OFF. This will allow
any fault in the system to show up immediately it occurs.
With the RESTART feature on:
1.
If a fault occurs in the machine, the diagnostic system will detect it. However, instead of
displaying a fault code immediately, the machine will try to RESTART.
2.
If the fault was only of temporary nature, the machine will restart and finish the cycle.
3.
If there is a continuous fault the machine will try to RESTART a number of times. This
process could take up to 8 minutes depending on the type of fault. After this, if the machine
still cannot restart, the fault code is displayed and the machine will beep continuously.
NOTE - This feature is designed as a service aid only and should be left ON in the
customer’s home. To return to normal operation, and to reset the RESTART feature to the
factory setting, switch the machine off at the wall or disconnect from the mains supply.
To identify that the RESTART feature has been activated, refer to the Restart / Recycle table.
(Refer to Section 6.2.4)
6.2.3 Recycle
Feature
At the end of servicing, the machine may require an extended test where the machine can be left
to complete a number of wash cycles. By turning on the RECYCLE feature, the machine will
continuously repeat the wash cycle until the RECYCLE feature is turned off. To toggle this feature
on or off, press the right scroll arrow. When the recycle feature is on, the word RECYCLE will be
highlighted.
NOTE - This feature is designed as a service aid only and should be OFF in the customer’s
home. To return to normal operation, and to return the recycle feature to the factory
setting, switch the machine off at the wall or disconnect from the mains supply.
To identify that the RECYCLE feature has been activated, refer to the Restart / Recycle table.
(Refer to Section 6.2.4)
6.2.4
Restart / Recycle Table LCD
As the LCD AquaSmart™ has only one LED (located above the High Efficiency button) the state of
the LED will signify which feature has been selected or not selected. The table below explains the
state of the LED when the machine is on at the wall and off at the machine.
LED: Off (Factory Default) Restart on
Recycle
off
LED: Solid
Restart off
Recycle
on
LED: Slow Flashing
Restart off
Recycle
off
LED: Quick Flashing
Restart on
Recycle
on
