Fisher & Paykel AeroDry, Installation Instructions And User Manual

Page: 10 / 24

8
Dryer position
The AeroDry™ dryer is front venting, whereby
the air is taken in through the grill at the rear
of the dryer and vented out through the grill
in the door at the front.
The dryer should be positioned so that the air
intake at the rear is unrestricted. The minimum
clearance needed from the wall is 50 mm.
Included with this dryer are two plastic spacers.
Fitting these on the rear of the dryer will ensure
the dryer is correctly positioned away from the wall.
■ ■
Use screws provided to fit the spacers (as shown in
the diagram).
Directional outlet grill
The outlet grill can be rotated to direct the exhaust
air. It should be adjusted so that it points towards an
external window or door.
Specifications
AeroSense™ and
AeroLogic™ dryers
AeroDry™ dryer
Dimensions
Width 565 mm 565 mm
Depth 560 mm 440 mm
Height 795 mm 795 mm
Electrical NZ / AU / Asia / Middle East NZ / AU
Volts 230/240 230/240
Hz 50 50
Amps 8.0 8.0
Note: if the electrical supply cord is damaged it must be replaced by the manufacturer or a
Fisher & Paykel Authorised Repairer in order to avoid a hazard.
Installation – AeroDry™ dryer
Fig. 10 Spacers
Fig. 11 Directional outlet grill