Installation instructions
8
Materials:
■
■
4” (102 mm) diameter rigid metal duct (recommended).
■
■
4” (102 mm) diameter UL-listed flexible metal duct (if needed).
■
■
4” (102 mm) diameter metal elbow(s).
■
■
Flexible metal gas line connector (for gas connections only).
■
■
Duct or spring clamps (2).
■
■
Pipe joint compound (pipe dope or tape) for gas pipe connections, resistant to LP Propane,
butane and natural gas (for gas connections only).
■
■
Exhaust/vent hood.
■
■
Duct tape.
■
■
Soap solution for gas leak detection (for gas connections only).
■
■
¾” (19 mm) strain relief (electric connections only).
■
■
Dryer power cord kit (power cord is not supplied with United States models).
Requirement: UL-rated 120/240 V, 30 amp with 3 or 4 prongs. Identify the plug type needed from
the existing house receptacle before purchasing. Length of cord must be at least 5 feet (1.5 m) long.
To the installer
Read these instructions completely and carefully.
■
■
These instructions must be left with the home owner for future reference.
■
■
Correct installation is the responsibility of the installer.
■
■
Installation of this appliance must be performed by a qualified installer.
■
■
The dryer
must
be exhausted to the outdoors.
■
■
Remove the door from an old dryer before it is removed and discarded.
■
■
The wiring diagram and service information can be found in the control console.
■
■
The Warranty does not cover product failure as a result of improper installation.
■
■
The dryer must be installed in a location where the temperature is above 50°F (10°C) to ensure
suitable operation of the dryer control system.
■
■
UL-listed duct material must be used. Discard existing plastic or metal foil duct and replace with
UL-listed duct material.
■
■
Observe all governing codes and ordinances.
■
■
Follow the installation instructions carefully.
Important!
■
■
Save these instructions for local electrical inspector’s use.
■
■
Observe all governing codes and ordinances.
■
■
Install the clothes dryer according to the manufacturer’s instructions and local codes.
