Installation instructions
37
Adding ducting for exhaust to the right or left side of the cabinet
■
■
Assemble a 4” (102 mm) elbow with a 4” (102 mm) length of duct. Secure the joint with duct tape.
■
■
Insert the elbow end of the duct assembly carefully through the side opening, and connect this
end to the internal duct of the dryer (inside).
WARNING!
Be sure not to pull or damage the electrical wires inside the dryer when inserting the duct.
Internal duct joints must be secured with tape, otherwise they may separate and cause
a safety hazard.
Duct tape
Exhaust can be added
to the left (gas or electric
models) or right side (electric
models only)
Fig.27 Left and right exhausting
■
■
Use duct tape (as shown in Figure 28) to secure the joint between the dryer internal duct and the
elbow, and also the joint between the elbow and the side duct.
Duct tape
Fig.28 Securing joints correctly with duct tape
■
■
Cover the original duct opening at the back with a plate (kit WE1M454), available from Fisher &
Paykel, refer to page 84).
Fig.29 Cover plate
