66
Dryer operation
Starting a drying cycle
Once you have chosen all your desired settings, ensure the door is closed and touch START/PAUSE
(located on the right-hand side of the control panel).
Stopping your dryer
Your AeroCare dryer can be stopped during any stage of the drying process, to allow you to
check on your load or add/remove clothes. To do this, simply open the dryer door or touch
START/PAUSE and open the door. There will be a slight delay as the drum slows down and stops.
To restart your dryer, close the door and touch START/PAUSE.
Important!
If you wish to stop the dryer before the cycle is finished, you MUST remove the clothes
IMMEDIATELY and spread them out to cool. DO NOT leave the clothes in the dryer or bunched up
in a clothes basket. There is a risk of spontaneous combustion.
If the cycle is interrupted before it progresses into COOLING, the clothes and parts of the drum
may be extremely hot. Take extreme care when removing the clothes load.
Finishing your cycle early
AeroCare will advance through the progress lights as it dries and will switch off once it has
completed the COOLING (final) phase of the cycle.
The COOLING phase means the heating elements switch off and the clothes are tumbled without
heat. When AeroCare senses the clothes are cool, the dryer will automatically end the cycle (this
takes between two and 10 minutes depending on the size of your load).
If you wish to finish your drying cycle early you can pause the current cycle and select the
AIR DRY cycle (select a cycle time of at least 10 minutes to cool the load down before removing it
from the dryer).
Beeps
At the end of the cycle, the dryer will beep to alert you that the load has completed drying.
You can modify the number of beeps that sound, or for the dryer to not beep at all. The dryer
defaults to five beeps. Please refer to page 72 for details on modifying the number of end of
cycle beeps.
