17
8
2032mm HEIGHT CAVITY – ATTACH ANTI-TIP BRACKET
Note: the overall cavity height of 2032mm is an optional installation for custom panels only.
IMPORTANT!
Safety requires refrigerators to be stable when door and/or drawer, are open. The anti-tip bracket and fittings supplied must be fitted to the wall of the finished enclosure to withstand
a 100kg load. This will prevent the possibility of the refrigerator tipping forward, when door and/or drawer, are open.
WARNING!
Failure to follow instructions can lead to serious injury or death.
When fastening with masonry plugs and/or screws:
●
●
Ensure the screws avoid electrical, gas and water conduits.
●
●
Ensure the surface the bracket is fastened to withstands a 100kg load.
●
●
Ensure light-weight masonry material such as cinder block and new concrete (no curing time) are not used in installation.
●
●
Do not use metallic materials that may corrode, stain and/or damage the enclosure.
A
min. 60mm
overlap
Bracket
PROFILE VIEW
Subtract 62 mm from
above finished enclosure
C
min. 60mm
overlap
Bracket
PROFILE VIEW
Subtract 62mm from
above finished enclosure
Spacer
B
min. 60mm
overlap
Bracket
PROFILE VIEW
Subtract 62mm from
above finished enclosure
For 2032mm cavity installation
Wooden/plaster board wall installation
1
Project the end of the above finished enclosure to the centre of the back wall and
subtract 62mm. This will locate the contact surface between the bracket and
the appliance (refer to
A
).
Ensure a structural beam/wall stud closest to the centre of the wall enclosure is located.
2
Fix bracket to the wall with screws x4 (#10 x 40 pan head Phillips screws).
Ensure screws hold tight and the bracket overlaps the appliance when it is positioned
(min. 60mm) for a secure hold.
Spacer installation
If a minimum 60mm overlap cannot be achieved we recommend fastening a solid
spacer (wooden beam etc) behind the bracket.
1
Ensure the length of the spacer corresponds to the enclosure’s width. Always
secure the spacer to existing studs on the enclosure wall (refer to
C
).
2
Fix bracket to the spacer with screws x4 (#10 x 40 pan head Phillips screws).
Ensure screws hold tight and the bracket overlaps the appliance when it is
positioned (min. 60mm) for a secure hold.
Solid wall installation
1
Project the end of the above finished enclosure to the centre of the back wall and
subtract 62mm. This will locate the contact surface between the bracket and the
appliance (refer to
B
).
2
Mark screw locations to drill Ø 6mm x 35mm deep holes. Hammer masonry plugs
into the wall until flush x4. Fix bracket to the wall with screws x4 (#10 x 40 pan
head Phillips screws). Ensure screws hold tight.
