4
Remote Basics
Remote programming procedure
The Firstech Control Module (
CM
) installed in your vehicle will support up to 4 remotes at a time.
NOTE:
Once all 4 remote banks are programmed each new remote that is programmed will delete a previously
programmed remote
IMPORTANT: All remotes must be coded to the control module prior to performing
all operations
Remote programming procedure for Standard Key start vehicle:
STEP 1:
Activate programming mode by manually turning the vehicle’s key between the
Ignition on and off
(or the Acc & On positions) five times within 10 seconds. The vehicle’s parking
lights will flash once with the successful completion of this step.
STEP 2:
Within a 10 second period after the 5th ignition cycle tap (a quick 0.5 second
press and release) the Lock button on the Firstech remote. The parking lights
will flash once to confirm the transmitter has been coded. Repeat step 2 for
each additional remote, up to 4.
Note: if you only have 2 remotes, please
program each remote twice.
NOTE:
If no valid remotes are programmed the CM will enter valet mode.
**vehicle parking lights may flash twice signaling the end of programming mode.
Remote programming procedure: PTS (Push to Start vehicles) application:
STEP 1:
Set the vehicle to the ignition or “ON” position
STEP 2:
Within 5 seconds push to the “OFF” position
STEP 3:
Within 5 seconds set the vehicle to the ignition or “ON” position (do not start)
STEP 4:
Within 5 seconds depress and release the foot brake 3 times *parking lights will
flash 1 time to indicate remote programming is enabled
STEP 5:
Tap (a quick 0.5 second press and release) the lock button on the remote * the
parking lights will flash 1 time indicating the remote code has been accepted
(Repeat step 5 for each additional remote, up to 4
