22
Troubleshooting:
Fault Probable
Cause
Solution
Water changes col-
our or becomes
cloudy.
Rower is in direct
sunlight or has not
had water treat-
ment.
Local tap water is
of poor quality.
Change rower location to reduce di-
rect exposure to sunlight. Add water
treatment or change tank water as
directed in the water treatment sec-
tion of this manual. Consider using
distilled water to refill tank.
Rower Belt slipping
off belt/ bungee pul-
ley.
Bungee not under
enough tension.
Recoil not strong
enough
Tighten bungee cord following the
instructions in "reattaching the rower
belt" section of this manual.
Inconsistent read-
ings on the Viking 2
AR Rower Comput-
er for 500meter split
time and SPM
(strokes per mi-
nute).
Sensor gap
Faulty Sensor
Sensor has moved
out of position
Wiring harness
Use the back cover of the computer
as a “Gap tool” to check the gap be-
tween sensor head and Magnetic
ring, or see if the Sensor head has
moved out of position.
Please contact your nearest FDF
customer service center for details
The Viking 2 AR
Rower Computer
does not illuminate
after battery installa-
tion.
Batteries installed
incorrectly or need
replacing.
Replace/reinstall batteries in correct
position and try again. If the LCD
screen fails to illuminate, try rotating
the batteries slightly in the computer.
If this fails, contact your local service
center.
The Viking 2 AR
Rower Computer
screen illuminates,
but does not register
when rowing.
Loose or failed con-
nection.
Sensor gap too
wide
Check that the computer lead is con-
nected properly. If it is connected
then contact your local service cen-
ter. Check Sensor gap