7
Start with the Rear Brace and on the underside you will find a pre-installed bolt.
From the hardware kit, take the Bungee Hook Mount and install it onto the Rear
Brace as shown. Note the orientation of the Brace and hook must be correct in
order to hold the end of the Bungee Shock Cord as depicted by the arrow in the
illustration, which points toward the front of rower.
Next, connect the
Side Rail Left[2]
and
Side Rail Right[2]
using
4x M6x15mm
Bolts[13]
and
Rear Brace[5]
. Do not tighten.
Rotate Rear Brace to correct orientation before
assembly onto Side Rails
M6 x 15mm Bolts
Rear Brace
M6 x 15mm Bolts
Side Rail Left
Side Rail Right
Transport Wheel
Assembly
Bumpstop
Side Rail/Rear Brace/Transport Wheel Assembly
Bungee Hook
Mount
Rear Brace
(Underside)
Towards Front of Rower
Pre-installed bolt
Tip: Bumpstops facing inside of rail for correct assembly orientation.
