7
Step 11.
Install the Frame
tensioning bolt and tighten
as far as it can go. This will
pretension the frame to the
proper position and com-
plete the assembly.
11
Carefully lower the rower to its normal operating position to
complete assembly with S-bend installation and frame ten-
sioning bolt.
Step 9.
Install rear of S-bend onto the upper frame using
M10x80mmbolt, M10Nylock and 2xM10washers.
9
S-Bend
10
Step 10
. Attach the S-bend to
the footplate as shown. Tilt the
upper frame slightly forward to
align in the proper position.
Note the M10x15mm S-bend
bolt w/washer is pre-installed
on the S-bend.
Keep fingers clear of pivoting parts and
rower seat when lowering to operating
position.
Caution
Summary of Contents for E-216 Fluid Rower
Page 1: ...Owners Manual ...
