First Alert FA148CP Series, Installation And Setup Manual

Page: 63 / 96

S E C T I O N 1 0
Creating Schedules
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
About Schedules
The FA168CPS system provides up to 32 schedules (FA148CP supports 8), which can be used to control
11 types of system events at pre-defined times. Sixteen schedules are intended for use by the end-user,
and sixteen are reserved for the installer (FA148CP = 4 user schedules, 4 installer schedules). In
addition, some events are also reserved for the installer only (listed in the “Enter Event” prompt
paragraph below).
Start Scheduling mode by entering installer code + [#] + [6] [4] while in normal operating mode.
NOTE: The master code can only access schedules 01-16 (FA148CP = 01-04) and events 00-07.
The following prompts are displayed:
PROMPT VALID ENTRIES EXPLANATION
E N T E R S C H E D N O .
0 0 = Q U I T 0 0
Schedule Number
FA168CPS
01-16 = end-user schedules
17-32 = installer-only schedules
FA148CP
01-04 = end-user schedules
05-08- = installer-only schedules
[
∗
] to continue
Enter the desired schedule number.
E N T E R E V E N T
NOTE: Events 07 and
10 cause the keypad to
beep every 30 seconds
when messages are
displayed. Stop the
beeps by pressing any
key.
Enter Event
00 = clear event
01 = Relay On/Off
02 = User Access
03 = Latch Key Report to Pager
04 = Forced Stay Arming
†
05 = Forced Away Arming
†
06 = Auto Disarm
07 = Display “Reminder”
10 = Display custom words
††
11 = Periodic Test Report
†††
[
∗
] to continue
Enter the desired event number for event you want to occur at a
specified time.
Events 10-11 are reserved for the installer only.
Latch key report (option 03) is sent to all pagers in the user’s
partition and is active only when the system is armed (message sent
is 777-7777). User must be enabled for paging (see User Attributes in
System Operation section).
† Forced bypass is automatically enabled regardless of setting in field
*23.
†† if selected, system displays custom words 8, 9, and 10 at defined
time. Can be used as installer’s reminder message to the end user.
††† see key commands in Testing the System section to quickly set
periodic test reporting intervals
D E V I C E N U M B E R
X X
Device Number
01-18 = device number
[
∗
] to continue
This prompt appears if event “1” (relay on/off) was selected, otherwise
it is skipped.
Enter the physical device number as programmed in
∗
79 Menu Mode,
then press [*] to continue to the “Start” prompt.
Device numbers 17 and 18 designate built-in triggers 1 and 2
respectively.
G R O U P N U M B E R
X
Group Number
1-8 = group number
[
∗
] to continue
This prompt appears if event “2” (user access) was selected.
Otherwise it is skipped.
Press [*] to continue to the “Start” prompt.
P A R T I T I O N
X
Partition
0 = all partitions
1 = partition 1
2 = partition 2
3 = common
[
∗
] to continue
This prompt appears if events “3-7,10” were selected. Otherwise it is
skipped.
Press [*] to continue to the “Start” prompt.
10-1