© 2022 Carrier
9
APPLICATION
Caution! Hot Surface Possible!
Danger of burns: The ignition rod may be hot after being pulled out of the combustion
chamber and also after ignition has taken place - wear protective gloves.
Attention!
The device is not suitalbe for continuous ignition!
Before commissioning, potential equalization should be carried out between the grounding bolt on the housing and
the front panel of the burner, for example with the optionally available potential equalization line
(at least 4 mm² PE cable with grounding clamp, length 3m).
Handle top view
Switching the device on and off
(Power On/Off)
The device is switched on and ready for
operation by pressing the latching switch
on the top of the device.
In the On state, the background LED lights
up in white.
Push the electrode of the portable ignition
device into the combustion chamber.
The ignition start (Ignition)
To ignite, the “ Ignition “ button (in front
of the handle on the side of the ignition
lance) must be pressed.
If the ring light turns red (Battery charge
indicator LED), the battery level is too low
and the batteries must be recharged.
Once the mixture has ignited, stop pressing the button to stop the ignition. After withdrawing the ignition electrode
from the combustion chamber, press the white-framed Power On/Off switch on the top of the device again to shut
down the device.
