© 2022 Carrier
10
ATTENTION!
Before each charging process, the connection cable and the plug connection must be checked for damage.
A defective charging cable must not be used and must be replaced. If any damage is detected, the device
must be sent to the manufacturer for repair
LOADING PROCESS
The rechargeable battery (three individual cells) of the hand-held ignition device is charged via the supplied mains cable.
Ignition is not possible during the charging process. Depending on the state of charge of the battery, this process can take
up to 2 hours. After charging, the hand-held ignition device must be disconnected from the mains.
If the ignition spark is very weak and the red background LED on the ignition button lights up, the battery should also be
charged. If batteries are allowed to drop below 3.0 volts, they can be permanently damaged.
Displays while charging
The charge status displays are located on the back of the hand-held ignition device.
When not in use, the device must be disconnected from the mains after the charging process has been completed.
To ensure full battery capacity, we recommend recharging the hand-held ignitor at intervals of approx. two months
and then disconnecting it from the mains again.
Green
LED lights up:
Charging process completed
Red
LED lights up:
Charging on
