11
3.0 SOFTWARE DESCRIPTION
3.1
MAIN MENU
The information contained in this manual is provided for an instrument fitted with all sensors and
available options. Therefore, some menus and associated options will not be available on individual
instruments.
NOTE: Gas readings cannot be accessed during re-calibration. When initiating the gas readings
mode, a confirmation of FUEL TYPE display will appear.
The main menu provides access to all other display menus. This is undertaken by using the keypad
and cursor keys.
1.
ON/OFF KEY: Switch between ON/OFF
2.
CURSOR KEYS: Scrolls up and down menus and also for selecting arithmetic values or other
options.
3.
ENTER KEY: Confirms selection.
4.
FUNCTION KEY: F1 selects HELP.
Gas Reading:
This menu and sub-menus provide access to all information regarding the measure-
ment of the gases.
Explanation of Terms:
The following represents detailed explanations about the information pre-
sented on screen.
Unit #:
The unique identification number of the instrument which applies to the measurement of
gases in a particular location. Any number between 0 and 99 can be used, to provide up to 99 unique
measurement locations.
To change this unique identification number requires access to the Setup menu, Section 3.4.
Fuel Type:
This represents the fuel type used at the specific location. This refers to the original fuel
used by the burner or furnace all of which have different burning characteristics and emission proper-
ties.The user definable options are: Wood, Light Fuel Oil, Heavy Fuel Oil, Natural Gas, Propane,
Coal and four alternative fuel option choices. To change the Fuel type refer to the Setup menu, Sec-
tion 3.4.
HELP
GAS READINGS
RE-CALIBRATE
SETUP
DIAGNOSTICS
DRAFT READING
DATA LOG
PURGE & PUMP OFF
F1
F2
F3
F4
MANUAL CAL.
ON/OFF SWITCH
FUNCTION
KEYS
CURSOR
KEYS
ENTER
KEY
FIRETRON
®
ANALYZERS
F1
F2
F3
F4
ON
STANDBY
SERVICE
CHARGE
LOW BATT
FAULT
ENTER
PROBE
Flue Gas
Draft
Exhaust
1
2
Hold 2secs.
On/Off
