13
11.
Install the contacts into the female insert in the appropriate order. When properly installed, the
contacts will “click” into the insert. Verify by pulling slightly on each wire.
12.
Place the threaded hood nut over the female insert.
13.
Slide the connector hood over the female insert, aligning the hood locating “key” with the wide
groove on the female insert.
14.
Tighten the threaded hood nut.
15.
Slide the second flat washer and the rubber seal into the connector hood. Push into place until
firmly seated.
16.
Wrap the shield drain wire around the cable jacket
one
turn only, (between the rubber seal and
the first washer, wrapped
clockwise
as viewed from the conduit or strain relief adapter), and trim
any excess length.
17.
Slide the first flat washer into the connector hood, on top of the drain wire.
18.
Thread either the Option 1 or Option 2 fittings and tighten firmly to properly compress the rub-
ber seal. This also compresses the first washer against the drain wire, electrically connecting the
shield to the connector hood. Torque to 35 inch pounds.
Before applying power, perform a continuity check on each conductor to confirm proper assembly.
Confirm that you have continuity between the cable shield (at the amplifier end of the cable) and the
quick disconnect hood (metal housing).
FIGURE 12.
QUICK DISCONNECT TERMINALS
FIGURE 13.
FOR EASE OF CONNECTOR ASSEMBLY, INSTALL ON END SHOWN
3
GREEN
RED
WHITE
FLAME SIGNAL
SHUTTER
COMMON
+24VDC
1
6
5
2
3
4
59-470
LEADS
7
1
2
BLACK
YELLOW
BLUE
RFS1 * (REMOTE FILE SELECT)
RFS2 * (REMOTE FILE SELECT)
5
7
ADDITIONAL
4
BROWN
COM A *
6
ORANGE
COM B *
and 471
59-471
LEADS
WIRE COLOR
PIN
FUNCTION
* USE THE SMALLER OF THE FEMALE CONTACTS FOR THESE FOUR 22 AWG WIRES.
RD
YL
GN
WT
BU
BK
RD
YL
WT
BU
BK
AMPLIFIER END
SCANNER END
CABLE
P/N 59-470 SHOWN
GN
