FireplaceXtrordinair 36 ELITE-ZC, Installation Manual

Page: 20 / 24

P
AGE
20
I
NSTALLATION
( C
ONTINUED
)
8 Attach the two male quick-connects from the switch plate to the two female quick-connects leading
from the fireplace. If the optional summer fan switch is being used, connect the other two quick
connects, otherwise tuck the two male quick-connects leading from the fireplace into the cavity
behind the faceplate. Attach the switch plate to the faceplate using a standard screwdriver (NOTE:
the attachment screws are threaded into the faceplate).
+ Blower operation may be checked by jumping the two male quick-connects leading from the
fireplace (BE CAREFUL - THIS CIRCUIT IS ACTIVE). Make sure the door is closed.
Attach the two male quick-connects from the
switch plate to the two female quick-
connects leading from the fireplace.
These male quick-connects are for the summer fan switch
(connect them together to test if the blower operates).
Use a standard
screwdriver to attach
the switch plate
Lower Right
of Faceplate
9 Test the blower circuit by following the directions below..
Remove the right
forward side brick.
AAAAAAAAAAAAA
AAAAAAAAAAAAA
AAAAAAAAAAAAA AAAAAAA
AAAAAAA
AAAAAAA
AAAAAAA AAAAAAA
AAA
AAA
AAA
AAA
AAA
AA
AA
AA
AA
AA
AAA
AAA
AAA
AAA
AAA
AA
AA
AA
AA
AA
a
Use a propane torch or
other heat source to heat
the area at the center of
this plate. The blower, if
connected properly,
should start within 30 to 60
seconds.
b
Depress the
door switch.
c