FireplaceXtrordinair 36 ELITE-ZC, Installation Manual

Page: 13 / 24

I
NSTALLATION
(C
ONTINUED
)
P
AGE
13
Chimney Requirements
• Use one of the following brands and type of chimney:
• Temco 82 • Superior TF8 • FMI 8DM • Marco 8D
Chimneys Part Numbers
C h i m n e y
C o m p o n e n t s
Temco 82 S u p e r i o r
T F 8
FMI 8DM M a r c o
8 D
12" Chimney Section 8212D TF8-12 12-8DM 12 - 8D
18" Chimney Section 8218D TF8-18 18-8DM 18 - 8D
24" Chimney Section 8224D --- 24-8DM ----
36" Chimney Section 8236D TF8-36 36-8DM 36 - 8D
48" Chimney Section 8248D TF8-48 48-8DM 48 - 8D
Offsets 8232E TF8-30, TF8-E30 30E-8DM 30E - 8D
Flashing 8206F 8-F6 6F8 or 12F8 12F - 8D
Chimney Cap 8203D TF8-CTO RTL-8HT BT - 8D
Roof Support 8204S 8-54 38 RS 12CPS - 8D
Firestop Spacer --- 8FS-2 FS-8DM FS30 - 8D
Chimney Connection to Fireplace
• Each brand of chimney has a slightly different outside diameter. To accommodate this, the fireplace
has three "L" brackets (outer liner connectors) on the top of the fireplace can. Center a section of
chimney over the chimney opening and mark the exterior location of the chimney. Then reposition
the "L" brackets, if necessary, so they are directly adjacent the exterior of the chimney. Use a drill
with a 5/16" driver bit to re-install the "L" brackets (use the existing sheet metal screws).
Outer Pipe Brackets
Use sheet metal screws to attach
the outer liner to these brackets.
Inner Liner (ledge along
inside accepts differed
sized chimney pipes)
If the outer pipe does not line up
with the brackets, remove the
brackets and re-attach them to
the top of the fireplace.
Connect the inner pipe to
the inner liner with three
sheet metal screws.
• When attaching the chimney to the fireplace, first slide down the inner liner of the chimney pipe into
the inner liner of the fireplace. Certain brands of chimney pipe will stop at the ledge, while others
will insert beyond the ledge. When the chimney pipe is fully seated and aligned, drill three holes in
the chimney pipe where it lines up with the holes in the fireplace inner liner. Secure the fireplace to
the chimney pipe with three sheet metal screws. If there are any large gaps between the chimney
pipe and fireplace, use furnace cement to seal (allow 24 hours to dry before burning the fireplace).