Kalea Bay Outdoor Fireplace
REV. 4-17-19 Page 30
Regulator
Plastic Stem
LP
Fig. 5
Regulator stem shown in LP setting
CAUTION:
Ensure the aluminum cap is installed with the
plastic stem seated completely into the cap and the metal
washer is installed with the aluminum cap.
Step 6:
Secure the aluminum cap with a screwdriver.
Step 7:
On the end of the burner pan where the pilot is
located (See Fig. 6), remove the four (4) 1/14” hex head
screws securing the metal pilot box. Two screws are
located inside the burner pan, one on each side of the
ignitor box screen mesh hood and the other two are
securing a metal tab on each side of the pilot box. See Fig.
6 for screw locations.
Metal Pilo
t Box
Bu
rne
r P
an
Fig. 6
Pilot box screw locations
Step 8:
Once the pilot box is loose and exposes the pilot
assembly then proceed to removing the pilot hood.
The pilot hood should lift straight up and out of the pilot
assembly. If not, remove the wire clip with a small
screwdriver or needle-nose pliers, then lift up. See Fig. 9.
Pilot Hood
Removable Clip
Vent Hole
(partially blocked
by brass orifice)
Fig. 7
Pilot hood removal
NATURAL GAS TO LP GAS CONVERSION
