11
OPERATION – UNITS WITH
GAS CONTROL VALVE continued
FIGURE 21 – PILOT ASSEMBLY
FIGURE 22
LIGHTING INSTRUCTIONS
UNITS WITH SAFETY PILOT
1-
STOP!
Read all warnings and safety information in this
manual.
2-
WARNING:
BE SURE THAT THE CHIMNEY DAMPER
IS FULLY OPEN!
LIGHTING THE PILOT
3-
Push in the gas control knob slightly, and turn it in a
clockwise direction to the OFF position. DO NOT FORCE!
NEVER USE ANY TOOL, TO ROTATE THE GAS
CONTROL KNOB! If gas control knob will not rotate,
contact your installer or the
fire
gear Service Center.
( SEE FIGURE 22 & 23 )
FIGURE 23
4-
Slowly, turn on the gas, at the manual shut-off valve,
beside the fireplace.
5-
STOP! WAIT FIVE ( 5 ) MINUTES!
6-
If you smell gas,
STOP!
7-
Turn off the gas at the manual shut-off valve, and recheck
all gas connections for leaks. Do not continue until all
leaks are corrected. Once you are assured that there are
no leaks, proceed with step eight ( 8 ).
8-
Locate the pilot. Pilot is located at the rear, right-hand
side of the unit.
( SEE FIGURE 20 & 21 )
FIGURE 24
9-
While holding a burning, long hearth match or hand fire
starter, near the pilot head, depress the gas control knob
all the way down, and turn the knob in a counter-clockwise
direction, to the pilot position. Continue to hold the gas
control knob down for approximately one ( 1 ) minute, after
the pilot is lit.
10- Pilot should remain lit, and control knob should pop back
out when released. If not, repeat the aforementioned
steps. If pilot ignition does not take place, contact your
installer or the
fire
gear Service Center.
PILOT
ADJUSTMENT
SCREW
