10
FOR VALVE/PILOT INSTALLATIONS continued
FIGURE 24
FIGURE 25
FIGURE 26
INSTALLING THE APPLIANCE INTO THE FIREPLACE
1- Place the ADVANTAGE BURNER BURNER PAN ASSEMBLY
into the fireplace. The unit should be centered from both side to
side, and front to back. ( SEE FIGURE 4 & 5 )
2- Bend a 3/8” gas line, with two ( 2 ) 3/8” brass, female flare fittings
( included on some models ), to facilitate the gas connection,
between the valve assembly, and the gas stub.
BE CAREFUL! Gas lines are easily kinked if bent too sharply.
3- Using an adjustable wrench, and turning in a clockwise direction,
attach a 1/2” Female Flare X 3/8” Male Flare Brass Reducer
Fitting ( included on some models ), to the gas stub.
4- Using two adjustable wrenches, and turning in a clockwise
direction, attach one end of the gas line, to the brass reducer
fitting that you have just installed on the gas stub. ( One wrench
on the brass gas line fitting, and one wrench on the brass reducer
fitting )
5- Using two adjustable wrenches, and turning in a clockwise
direction, attach the other end of the gas line to the brass fitting
on the valve assembly. ( One wrench on the gas line fitting, and
one wrench on the brass fitting on the valve assembly )
BE CAREFUL! Make sure all gas connections are snug, but DO NOT
over tighten!
6- It is our recommendation that, at this point of the installation,
lighting the pilot, and test ignition should take place. Go to
the section “OPERATION – UNITS WITH GAS CONTROL
VALVES” ON PAGE 15.
FOR UNITS WITH GAS CONTROL VALVES
, see “UNITS WITH
REMOTE SYSTEMS” section, on page 11 and “LIGHTING
INSTRUCTIONS WITH SAFETY PILOT” on page 16.
7- CHECK FOR LEAKS! Apply soapy water to each connection and
watch for bubbles. If bubbles are seen, turn off the gas supply;
retighten the connections, and CHECK AGAIN! DO NOT use a
lighted match or other source of ignition to check for leaks.
Repeat this procedure until you are sure that there are no leaks in
the gas connections.
8- When you are assured that there are no gas leaks present, you
may proceed to the “ FINAL SET UP “ section, on page 13.
