Cygnus User Manual
-
v3.0 2011
Page 6
2. Ge ng Started
2.1
Storage
1.
Cygnus is designed to be used and stored outside. However, to prevent unnecessary weathering it is recom-‐
mended that the unit is stored inside when possible.
2.
It is recommended that the ba ery bank is charged regularly while in storage. Refer to Chapter 4, Sec on 5 for
further informa on.
3.
Cygnus should be switched off when in storage and not being charged to prevent unnecessary discharge of the
ba ery bank.
2.2
Transporta on, Loading/Unloading & Posi oning
2.2.1
Transporta on
1.
Cygnus can be transported using a suitable trailer, light or heavy goods vehicle with adequate available
payload. Check the relevant transporta on documenta on for suitability.
2.
The gross weight of the unit can be found on the ra ng plate posi oned on the le hand side of
the unit. Please note that different models have different weights.
3.
It is recommended that the unit is secured using suitable straps when in transit to prevent it from moving.
2.2.2
Loading/Unloading
1.
Cygnus must be loaded or unloaded using the correct equipment operated by suitably trained personnel.
2.
Using the li ing ring; Cygnus can be li ed onto or off from transporta on. The li ing ring is suitable for li ing
all models of Cygnus regardless of the unit’s gross weight.
3.
Using the fork pockets; Cygnus can be loaded or unloaded with a suitable fork
-
li truck.
2.2.3
Posi oning
1.
The unit must be posi oned upright on a flat, solid surface. Ensure that the unit is not at risk from being sub-‐
mersed in water above the fork pockets.
2.
The unit should be posi oned as close as possible to the chosen charging system (e.g. solar array, Kinectrics
equipment, wind turbine) and close to its earth point.
Always check the ra ng plate to ascertain the gross weight of the specific unit in ques on.
Refer to the fork
-
li truck opera on manual for li ing capacity and manufacturer’s opera ng instruc-‐
ons.
The unit must remain upright at all mes.
