Cygnus User Manual
-
v3.0 2011
Page 21
6.2
Appendix 2
-
24V DC SPEC Pak Input/Output
The Spec Pak socket (Fig. 1, F1) is a 24V 2 x 40A input and output connector.
The socket can be used to connect Kinectrics equipment (refer to Appendix 3, (6.3.5)) or a wind turbine for charging the
unit. Only Firefly Solar approved equipment should be plugged into this connector. Contact the manufacturer for a list
of approved wind turbines.
This can be used as an unregulated 24V output. Contact the manufacturer for more informa on about suitable
adapters and appliances.
6.2.1 Connec ng the SPEC Pak Plug
1.
The SPEC Pak socket is fi ed with a waterproof cover (Fig. 5, Step 1).
2.
Remove the cover by hinging up the retaining clip and pulling out (Fig. 5, Step 2).
3.
Insert the connector, hinge down the retaining clip to secure (Fig. 5, Step 3).
6.2.2 Disconnec ng the SPEC Pak Plug
1.
Disconnect the plug by hinging up the retaining clip and pulling out the plug (Fig. 5, Step 2).
2.
Replace the weatherproofing cover
3.
Hinge down the retaining clip to secure (Fig. 5, Step 1).
Fig. 5
-
24V 80 A DC SPEC Pak Connector
The weatherproofing cover must always be replaced when the SPEC Pak socket is not in use. Failure to
do so may cause water ingression damage to the unit and invalidate the warranty.
