Cygnus User Manual
-
v3.0 2011
Page 10
3. General Opera on
3.1
Turning the Power On
Once all the above connec ons are complete, the unit is ready to be switched on.
1.
Ensure that the Emergency Stop bu on is not depressed by rota ng clockwise (Fig. 1, C6)
2.
Switch on the RCD and MCB switches (Fig. 1, B1 & B2).
3.
Switch on the unit using the Power On/Off Switch (Fig. 1, C4).
4.
As the unit is switched on, a loud beep will be heard and the RCC
-
03 (Fig. 1, C2) backlight will illuminate.
5.
The unit is now in standby mode.
6.
“Message 012 use of ba ery temperature sensor” will be displayed for five seconds.
7.
A er which, the following should be displayed:
8.
Press ESC on the RCC
-
03. The message ‘Turn the System On?’ will be displayed.
9.
Press SET to accept and the unit will go out of standby mode and turn on. A number of changes will appear on
the RCC
-
03.
10.
The following will be displayed on the RCC
-
03:
11.
The unit is now on and ready to supply power to connected consumers.
Fig. 2
-
RCC
-
03, Unit in Standby
Fig. 3
-
RCC
-
03, Unit On
