Page 3 of 6
ICAF -
Integrated Compressed Air Foam System
B
Control Panel Section
FM-0723-0-26B
System temperature is displayed in the lower part of this
screen. Trouble signal will be activated on high or low
temperature indications (levels are factory defined). This
value is used for system performance analysis and should
not be used as a thermometer.
While in this screen, pressing on the
RIGHT
or
LEFT
keys will
scroll to display the
BATTERY INFO. / GROUND FAULT
status
screen or the
TIMER STATUS
screen as shown below.
In the
BATTERY INFO
screen the upper portion of the screen
displays the actual battery voltage, current and size. A minus
sign in the Battery Current indication shows battery load
when the system is powered by the batteries:
-
BATTERY SIZE
is displaying the value entered initially at the
factory or by the user. Refer to
MENUS – BASIC SETUP
for
additional details.
CHARGING MODE
is also displayed in this
section as per the current status of batteries:
-
TRICKLE
indicates a fully loaded battery on low charge
mode.
-
CHARGING
indicates a low battery condition on high charge
mode and will also display a timer showing how long the
condition has been active.
-
DISABLE
is displayed whenever the charger is turned off.
This condition appears when system is in alarm state,
when a battery fault has occurred or when AC power is off.
-
TEST
indicates that the batteries are in the system's
automatic battery test mode (after a cold start or 30 days
after last test). This mode also displays a timer showing
how long the condition has been active. If a bad condition
of battery is detected, system will go on trouble condition.
The bottom section's
GROUND FAULT STATUS
indication is
for technician use and displays factory codes on Ground
Fault condition for troubleshooting purposes. Refer to
TROUBLESHOOTING
section for additional details.
In the
TIMER STATUS
screen, all the set values of the
various timers are displayed as shown in the example
below (actual screen may differ depending on system
configuration):
Pressing on the
MENU / EXIT
key will exit the display
altogether and return to the default screen.
Note:
Next time the user will access this display, system
will automatically return to the last screen it was
displaying before exiting, making a quick return to the
same data much easier.
MENU / EXIT
:
Pressing and holding this key for
2 seconds activates the user menu screen on the
alphanumeric display and when pressed once
within a menu item, is used to exit from this menu item.
To exit from the menu entirely, press and hold the key for
2 seconds. Typically, the display will automatically
return
to its default mode if no key activity is detected for a
period of about 5 minutes.
Once modifications have been done in a menu section,
exiting the menu will save all the new data for the entire
section in the system's memory. Individual items don't
need to be saved individually.
5. Keyboard -
Function keys
These three keys are configured for
special functions adapted to the
ICAF system mode, but their
programming is not accessible to the user and is made at
the factory. The keys functions are only available to the
user when in the Normal Screen and while navigating
through the System Events Screen.
Note:
The keys usage is also contextual – depending on
the menu or utility, they can be used to perform other
systems related functions.
F1
F2
F3
Summary of Contents for ICAF System
Page 1: ...Operation Maintenance Manual FM 0723 0 02 A ...
Page 7: ...OWNER S OPERATION MAINTENANCE MANUAL ICAF Integrated Compressed Air Foam System FM 0723 0 5B ...
Page 27: ...Page 4 of 4 ICAF Integrated Compressed Air Foam System System Trim Section FM 0723 0 10 A ...
Page 41: ...Page 2 of 2 J ICAF Integrated Compressed Air Foam System User Notes FM 0723 0 16D User Notes ...
