Fireco Dorgard X2, Fitting And Operating Manual

Page: 11 / 36

10
Installation
Note. Dorgard X
2
will not operate until the Batteries
have been inserted and it has been Linked to a
System X transmitter.
1. Ensure the Batteries are installed and the Dorgard X
2
is
Linked to the designated System X transmitter.
2. Close the fire door. Place the Template provided against
the door on the side that shuts against the door frame.
Ensure the Template matches your view of the door.
3. Please make allowance for differing floor surfaces.
4. Make pilot holes or mark the position for the holes
through the Template.
5. Using 2 of the 4 stainless steel Screws supplied, fix
Dorgard X
2
to the fire door at points A and B of the fitting
Template. This will allow Dorgard X
2
to be moved up and
down slightly for correct positioning. The correct position
is when the Dorgard X
2
Plunger is fully retracted, the door
can swing free. When the Dorgard X
2
Plunger is depressed,
contact with the floor or Floorplate holds the door open.
When Dorgard X
2
is in the correct position fasten down all
4 Screws.
6. Affix a Fire Door Sticker each side of the fire door, at eye
level.
Dorgard Spacers are available to space the Dorgard X
2
out from the door front if door features or decoration
prevent use of the Plunger or the Battery Lift.