IPDACT Module - Configuration
IV-39
Doc.
Dm373-I
Rev.
2.0
IPDACT IP address and mask
01
IPDACT access gateway
02
IPDACT account number
11
Main VisorAlarm IP address
12
Backup VisorAlarm IP Address
21
UDP Port
13
b) If you have a DHCP server
Type of register
Register
IPDACT account number
11
Main VisorAlarm IP address
12
Backup VisorAlarm IP Address
21
UDP Port
13
After configuring these parameters and restarting the device, the installer
must re-access the telephonic console as previously described and access
register 04. Here the installer password configured in the
VisorALARM
must
be configured. If the IPDACT has IP connectivity with the
VisorALARM
and
the password is correct, the IPDACT will receive the configuration defined in
the profile configured in the
VisorALARM
.
Through this mechanism, the installed IPDACT is registered in the Teldat
VisorALARM
which from this point begins to monitor the former and the
IPDACT receives the necessary configuration in order to exchange
information with the Teldat
VisorALARM
.
If the whole process has gone smoothly, the IPDACT will begin to exchange
monitoring messages with the VisorALARM and from this point onwards the
IPDACT telephone relays activate (the line status LED lights up).
IV - 3.1.4.
Configuration Example
In cases of configuring the IPDACT with the following data:
IP address: 192.168.1.100, mask 255.255.255.0
Access GW: 192.168.1.20
IPDACT account number: 1234
Main VisorAlarm IP: 10.24.6.1
Backup VisorAlarm IP: 80.6.189.123
UDP port: 3000
The registers and the data are, in cases where the testing digit is disabled
(through register 49):
Summary of Contents for IPDACT
Page 1: ...IP Communicator IPDACT Installation Manual Document DM373 I Version 2 0 March 2007...
Page 19: ......
Page 29: ......
