IPDACT Module – Installationg and cabling
III-19
Doc.
Dm373-I
Rev.
2.0
Figure 14. IPDACT installation in the box.
III - 1.1.
Assembly Instructions for the IPDACT box
The instructions in order to assemble the IPDACT in its box are as follows:
1. Attach the box to the wall; the maximum distance this can be from
the control panel is 6.1 meters (twenty feet).
2. Remove screws 1, 2, 3 and 4.
3. Place the IPDACT board so orifices A, B, C and D coincide with the
bolts.
4. Insert the four bolts into the orifices and slowly tighten them until the
board is firmly attached to the box.
5. The box has two ground connections (T1 and T2).
6. Connect the T1 earthed ground to the panel earth using an AWG 14
cable.
7. The stamped openings available in the box permit wiring to both
enter and exit the box through conduits. Please remember that in
Summary of Contents for IPDACT
Page 1: ...IP Communicator IPDACT Installation Manual Document DM373 I Version 2 0 March 2007...
Page 19: ......
Page 29: ......
