Version: August 2020
26
How to lay Forest Logs Firebed - GD12 1200
• Lay logs and large rocks first, in these positions.
• Lay rocks next, in these positions.
• With glass still removed, the safety switch held back with masking tape, using the remote control, switch the
appliance ON, following the
‘GD12 Operating Instructions’
in this guide to check how flame looks. The
flame will take 20-25 seconds to light fully.
•
IMPORTANT:
the flame effect should look natural and non-uniform, running the entire length of the burner.
•
Common flame effect issues are:
•
Flame touching edge of burner tray.
•
Missing flames along length of burner.
•
Both these issues can be resolved by switching the appliance OFF and slightly repositioning rocks and logs
at the problem areas. Follow the
‘GD12 Operating Instructions’
in this guide.
•
Repeat this switching On/Off and repositioning until a natural and non-uniform flame effect is achieved.
•
Once a natural and non-uniform flame effect is achieved, switch the appliance to the lowest setting and
ensure the flame effect, although smaller, still looks good.
•
Switch the appliance OFF, remove masking tape over safety switch and carefully install glass by following
the
‘Glass installation process’
in this guide.
•
Switch the appliance ON and then down to the lowest setting to check that flame effect still looks natural and
non-uniform.
•
Using the remote control, switch the appliance OFF following the
‘GD12 Operating Instructions’
in this
guide.
•
Switch the wall isolation switch to the appliance OFF.
•
Note:
it is normal for the glass to mist a little when the appliance is first switched ON. This will quickly
disappear.
•
Switch the appliance OFF.
