Version: August 2020
16
Step 5: Connect and test electrical supply
•
All electrical connections must meet the requirements of AS/NZS 3000 standards and be installed
and certified by a suitably qualified person.
•
In order to access the electricals, it is necessary to first remove the glass and the burner tray.
•
Follow the ‘
Glass installation
process’
in this guide.
•
Lift glass away from the appliance and lay flat in a safe place with insulating material facing down.
•
Remove the burner tray by following the
‘Burner Tray Removal Process
’ in this guide.
•
With the burner tray removed the electrical connections between the appliance and the wall isolation switch
can be seen, use 3 core (minimum 1mm) cable from the wall isolation switch.
•
Following these connection details, using the 3 core cable that has been run at site, connect the wall
isolation switch to the appliance
•
IMPORTANT: Before testing, ensure the gas valve is
turned OFF.
•
The GD12 models have for each glass panel a safety
switch, at the base of each lower opening. The safety
switch turns the appliance off if the glass is not in the right
position. The safety switch will need to be held down to
complete electrical testing. It is recommended that
masking tape is used to hold the safety switch down.
•
Test electrical functions by switching the wall isolation switch to the appliance ON.
•
Using the remote control, switch the appliance ON, following the
‘GD12 Operating Instructions’
in this
guide.
•
The fan will start and after approximately 25 seconds, the pilot will spark. Because the gas supply is turned
off, the pilot will spark for approximately 25 seconds then automatically switch off.
•
Using the remote control switch the appliance OFF, following the
‘GD12 Operating Instructions’
in this
guide.
•
Switch the wall isolation switch to the appliance OFF. Electrical testing is complete.
•
Install the burner tray by following the
‘Burner tray installation process’
in this guide.
•
NOTE
: The masking tape must be removed once testing is completed.
•
Carefully install glass by following the ‘
Glass installation
process‘
in this guide.
Safety switch
