4
combustible floor. Position the furnace as close to the chimney as possible. Air for combustion must be provided into the room where the
furnace is located. Allow air free access to the furnace for combustion and ventilation.
RECOMMENDATION: Purchase Chimfex™ Dry Chemical Chimney Fire Extinguisher. These are readily available at most stove shops
and hardware stores. Smoke detectors should be installed on all levels of your home. Having a fire extinguisher in the furnace room or
area is strongly recommended.
Assembly
of
Unit
Please review the parts list and diagrams contained on pages 15 - 17 of this manual.
DOUBLE CHECK TO MAKE SURE YOU HAVE RECEIVED ALL THE REQUIRED
COMPONENTS. IF YOU FIND THAT THERE IS A PART MISSING, CALL
1-800-875-4788 FOR FASTEST SERVICE, PLEASE DO NOT GO BACK TO THE
DEALER. DEALER DOES NOT CARRY REPLACEMENT PARTS.
NOTE: For your convenience your Fire Chief Furnace has been factory assembled and the electrical control assembly pre-wired.
1. Fasten the right and left side angle brackets to the
circulation blower using (4) ¼ - 20 bolts and nuts.
Line up the blower with the pre-drilled holes on the
backside of the furnace, firmly attach with the
screws provided.
Mounting Screw
Blower Assembly
Blower Assembly
Mounting Screw
Blower Assembly
Mounting Screw
2. Attach blower to the left and right mounting brackets.
RETURN AIR DUCT
SUPPLY DUCT
BACK DRAFT
DAMPERS
OPEN/CLOSE
RETURN DAMPERS
3 PLACES
1/4-20 Bolt
Four Places
1/4-20 Nut
Angle Bracket
1/4 - 20 Nut
1/4 - 20 Bolt
Angle Bracket
