21
RELOADING PROCEDURE
1. Start at step 2 in LOADING on page 15.
2. After last load of the day, refer to CLEANING AND MAINTENANCE.
CLEANING AND MAINTENANCE
AFTER FIRST 4 TO 8 HOURS OF OPERATION
Torque wheel lugs. Torque again after 7 days (Trailer option only) to 75 lb-ft (102 N•m).
DAILY
1. Cleaning the HydroSeeder®:
A. Fill slurry tank to center of agitator shaft with clean water.
B. Move agitator lever to full speed to flush off inside of tank top and walls.
C. Remove discharge nozzle and coupler gasket from remote valve coupler at the end
of the discharge hose (or from boom on the platform option).
D. While aiming discharge hose or boom toward an open area, open discharge and
remote valve and engage (turn on) clutch. Allow to discharge until clear water is
coming out.
E. Open the recirculation valve and allow to run until the stream is clear.
F. Disengage (turn off) clutch, idle the engine, move discharge valve handle to DIS-
CHARGE position, move agitator handle to NEUTRAL, and turn off the engine.
G. Remove drain plug and allow tank to drain.
H. In freezing weather, leave main tank drain plug out and remove pump drain plug.
Move all slurry valves to open position.
I. Wash the outside of HydroSeeder® to remove any corrosive materials.
J. Replace coupler gasket before reinstalling discharge nozzle onto remote valve cou-
pler.
2. Lubricating the HydroSeeder® (see LUBRICATION AND FLUIDS CHART on pages 32 and
33):
CAUTION
Lubrication should be performed IMMEDIATELY AFTER cleaning of the equipment, making
sure the engine is not running. Failure to comply could result in minor or moderate per-
sonal injury. Failure to comply could also result in product or property damage.
A. Lubricate agitator shaft bearings located on the outside-front and rear of slurry tank.
B. Service automatic pressure lubricator on pump as needed. See pages 8 and 9.
C. Check engine oil and replenish when necessary. Change oil and filter after first 5
hours, then every 100 hours thereafter. Consult the engine operator’s manual for cor-
rect grade of oil and engine break-in procedure.
D. Lubricate swivel on discharge boom assembly (Platform Option only).
Summary of Contents for HydroSeeder T60-II MD
Page 2: ...II NOTES II...
Page 36: ...30 6 1 4 5 7 2 7 9 9 2 8 10 3 Figure 7 Lubrication and Adjustment Points...
Page 38: ...32 NOTES 32...
Page 64: ...58 NOTES 58...
