9
4. Check hydraulic oil level and fill if necessary. See HYDRAULIC SYSTEM on page 23 for oil
specifications.
5. Check engine oil level and fill if necessary. For oil type, refer to the engine manual.
6. Inspect air cleaner for dust and dirt; clean if necessary.
7. Secure the tank drain plug in the drain pipe located in the center of the bumper.
8. Check to make sure pump drain plug is in place.
9. Lubricate equipment – See LUBRICATION AND FLUIDS CHART.
A. Each lubrication point on the machine is marked with a decal.
B. Check automatic pressure lubricator at pump. If the stem is fully extended, with
thumb nut all the way up, the automatic pressure lubricator contains lubricant. If
the lubricator does not contain lubricant, the lubricant must be replaced by using the
following procedure (see Figure 1, page 9):
1. Turn thumb nut clockwise until stem rises to maximum height.
2. Remove cap and fill cap with sodium- (water soluble) based grease
(FINN part number 000698). Do not use lithium-based (chassis lube)
grease.
3. Replace
cap.
4. Turn thumb nut counterclockwise until the thumb nut is at the top of the
stem. The spring and pressure disc in the lubricator forces the grease,
under pressure, to the pump seal.
NOTICE
When the thumb nut has moved down to within 1/2 in. (1.27 cm) of touching the cap, re-
service the automatic pressure lubricator.
10. Check nozzles and hoses and clean them of any obstructions.
11. Check pump discharge, recirculation, and remote valve handles for free movement.
Thumb Nut
Stem
Cap
Spring
Pressure Disk
Grease
Figure 1
–
Automatic Pressure Lubricator Components
Summary of Contents for HydroSeeder T60-II MD
Page 2: ...II NOTES II...
Page 36: ...30 6 1 4 5 7 2 7 9 9 2 8 10 3 Figure 7 Lubrication and Adjustment Points...
Page 38: ...32 NOTES 32...
Page 64: ...58 NOTES 58...
