Finn HydroSeeder T60-II MD, Parts And Operator'S Manual

Page: 13 / 64

7
CAUTION
Your FINN HydroSeeder® should be mounted by a qualified truck body installer. Failure
to comply could result in minor or moderate personal injury. Product damage could also
occur.
When mounting the HydroSeeder® to the truck, one of the following methods of mounting is
acceptable:
1. Bolt the HydroSeeder® directly to the truck bed. Installer must ensure that the bed-to-truck
and HydroSeeder®-to-bed connections are adequate for the maximum weights loaded that
are shown on page 6.
2. Mount the HydroSeeder® to the truck frame. The T60 II Skid HydroSeeder® is provided
with an adapter frame that also allows the unit to be mounted directly to the truck’s 34 in.
(86.4 cm) wide frame using U-bolts.
NOTICE
Mounting the HydroSeeder® to the truck must allow for tire clearance and frame twist.
Place hard wood spacers along the length of truck rails or use FINN Spring-Mounting Kit
(part number 011562) or equivalent.
3. Place chains over the HydroSeeder® and around truck bed and secure with binders. Secure
the HydroSeeder® with blocks tied to the truck bed.
CAUTION
When using a truck with a tilt bed, make sure to chain the truck bed down to prevent the
bed from being accidentally hoisted. Failure to comply could result in minor or moderate
personal injury. Failure to comply could also result in product or property damage.