Finn A2548-001, Operator'S Manual

Page: 8 / 133

2
MATERIAL BLOWER SAFETY SUMMARY SECTION
It is important that all operators of this machine are familiar with all the safety aspects
mentioned below before operating the machine. Always keep a copy of this manual with
the machine. It is the responsibility of the operator of the machine to fully understand this
safety section. Remember that YOU are the key to safety. Good safety practices protect
not only you but also the people working with and around you. Keep in mind that this safety
sheet is written for this type of machine only. Practice all other usual and customary safe
working precautions; and above all, remember that safety is up to you.
I. PRE-START EQUIPMENT CHECK
(equipment check is to be made with the
engine off)
1. If you have a chassis-mounted unit, check devices
securing unit to the truck or trailer frame.
If the unit is a trailer unit, check
hitch and hitch bolts, lights, brakes,
and all safety components. Verify
that the hitch ball or pintle hook is
the correct size for the coupler.
2. Verify that all guards are in place.
3. By carefully looking into the blower hopper and
transition, inspect for and remove any foreign
objects. Follow Occupational Safety and Health
Administration (OSHA) lockout/tagout procedure
(29 CFR 1910.147)
4. Inspect all hydraulic hoses and tubes for cracks,
bulges, or damage. If hose is cracked, bulging, or
damaged, replace immediately.
5. Inspect the material discharge hose and
connections for cracks or damage. If cracks
or damage are found, replace affected part
immediately.
II. MACHINE OPERATION
1. Always wear safety goggles when
operating and/or feeding the
machine. Other safety attire, such
as safety shoes, ear protection,
gloves, hard hats, dust masks,
etc., should be worn as required
by warning decals on machine,
operator’s manuals, or job site requirements.
Remove rings, watches, etc. Avoid wearing loose-
fitting clothing that may get caught in rotating
machinery.
2. Do not override or tamper with the safety-shutdown
switches on the airlock door or discharge. If
switches fail, use OSHA lockout/tagout procedure
(29 CFR 1910.147) until switches are repaired or
replaced.
3. Do not operate the machine without
all guards in place.
4. Never attempt to connect, or disconnect the
discharge hose while the engine is running.
5. Make sure that no one is working
in or on the machine. Make sure
the discharge area is clear of
all persons, animals, etc. Signal
visually or audibly that all is clear
before starting the engine. Keep
unauthorized personnel away from
the machine and discharge hose at all times.
6. The driver of the towing vehicle is responsible for
the safety of the operator(s) and feeder(s) of the
machine. Make sure the driver is aware of and
avoids all possible hazards, such as tree limbs, low
power lines, etc.
7. Do not allow anyone to ride on the trailer or any
other part of the unit for any reason.