17
PRE-START EQUIPMENT CHECK
Equipment check is made with the engine off and all rotating parts
stopped. Failure to comply could result in minor or moderate
personal injury. Failure to comply could also result in product or property damage.
Safety check to ensure operator safety:
1. Ensure that all guards are in place.
2. Tool Kit - see that it contains all prescribed items (see Tool Kit list).
3. Lubricate equipment - use hand gun only (see Lubrication Chart).
4. Check engine oil - refer to engine operator’s manual.
5. Check liquid coolant level in radiator and overflow tank. (Protected to -34ºF (-37ºC) when
shipped.)
6. Inspect the engine air cleaner (refer to the engine operator's manual), the radiator chaff
screen, and blower air cleaner for dust and dirt. If necessary, clean or replace the air
filters.
7. Check fuel level. Use only Ultra-Low-Sulfur diesel fuel.
8. Check hopper and transition for foreign objects that could injure workers or damage
equipment when the machine is started.
9. Ensure that tarp is open and secured in place. Never operate machine with tarp covering
hopper.
Allowing the tarp to hang or sag over hopper during operation raises
the risk that the tarp will be pulled into the equipment. This will cause
damage to the unit and could be a risk to the safety of the operator.
10. Check the fluid level in the hydraulic tank. Proper level is 3/4 in. from the top of the sight
gauge. (See Lubrication Chart for oil specification.)
11. Install the discharge hose, using clamps and gaskets provided with the machine.
Do not use radiator-type clamps. These clamps may not hold under
machine-operating pressure. Failure to comply could result in minor
or moderate personal injury. Failure to comply could also result in product or property
damage.
12. Check to verify the radiator is free of mulch and debris obstruction to ensure over heating
does not occur.
Do NOT use high pressure water to clean out radiator
fi
ns because
damage will occur to the delicate radiator
fi
ns.
Summary of Contents for A2548-001
