1
TECHNICAL SPECIFICATION
Power supply:
3x1.5 V alkaline batteries type AAA - LR03
Temperature adjustment: (+5…+37)°C
Resolution:
0.1°C
Degree of protection:
IP20
Output: 5 A 250 V AC changeover volt-free contact
Mounting:
Wall
INSTALLATION NOTES
SAFETY REQUIREMENTS
The installation and assembly of electrical equipment must be
performed by experienced personnel. Before connecting the
thermostat, make sure that the load (pump, valve, boiler, etc.) is not
powered and that it falls within the thermostat’s contact rating.
POSITIONING
Install the thermostat away from heat sources (radiators, direct
sunlight, kitchens), away from doors/windows, and mount
approximately 1.5 meters above floor level.
ELECTRICAL CONNECTIONS
To make the connections, first refer to instructions for your heating
system (pump, valve, boiler, etc.), then remove the terminal cover
and connect the appropriate wires to terminals 6 (COM) and 7 (NO)
of the Smart Bliss2 thermostat.
Type 01C.02.8.230.0500
:
OPTIONAL power supply
Using the external power supply, the batteries MUST be removed.
NC
NO
C
01C.02.8.230.0500
EASY INSTALLATION
FIXING BASE TO WALL
First, detach thermostat from its base by inserting two fingers into
the central rear hole and, with the other hand, pull the front of the
thermostat towards you.
FIXING BASE
Secure the Smart Bliss2 thermostat base to the wall using the screws
included in the package. When fixing, be careful not to over-tighten the
screws to avoid damaging the base.
